• Bekafun
  • Celto Acoustique C2.10 - 2X 1100W amplifier

Celto Acoustique C2.10 - 2X 1100W amplifier

CTO-C210

- Robuuste versterker
- 2x 1100W 4 Ohm (2x 750W 8 Ohm) max vermogen
- Lineare ringkerntransformator met aluminium
- Piekbegrenzer met lage vervorming
- Class H eindtrap
- Bescherming: Softstart, Kortsluiting, Overspanning, Overstroom, Overbelasting, DC-uitgang, Temperatuur
- 16 kg gewicht


€ 805,66
prijzen incl. taksen en BTW

Vanaf 8 St aan 765,37 € (5% korting) Tijdelijk niet op voorraad

Max output Power EIA 1kHz 1% THD (EIA = 33ms ON / 66ms OFF): 2x 750W 8 ohms | 2x 1100W 4 ohms | 1x 2200W 8 ohms (Bridge)

Overall gain: 35dB (50 times voltage)

Sensitivity at 8 ohms: >108dB

Frequency Response (-1dB): 20~20000Hz

Typical THD (half power, 1kHz, 8 ohms): <0.1%

Typical IMD (1kHz at 4:1, -20dB): <0.3%

Crosstalk (1kHz): >65dB

Slew Rate: >20V/us

Input Impedance: 20 kΩ

Damping factor (1kHz, 8 ohms): >500

Protections: Soft-Start, Short-Circuit, Over-Voltage, Over-Current, Over-Load, DC Output, Temperature

Operating Voltage: 190~260VAC 50-60Hz

Preamp: Low noise and low distortion circuit, PeakStop Opto-Limiter

Power Supply (PSU): Linear topology with toroidal transforner

Output stage: 2-step Class H without cross-rail distortion (70% efficiency)

Cooling: Front to back airflow, Temperature regulated fans, Copper heat-sink for maximum heat transfer

Rear Panel: 2 NEUTRIK XLR Input with latch, 2 NEUTRIK XLR Link ,2 NEUTRIK Speakon NL4, 2 speaker Binding post terminals, Stereo / Parallel / Bridge switch, Ground / Lift switch, Magnetic Breaker, PowerCon 20A (Included)

Speakon Wiring: SPK1 = 1+1- CH A / 2+2- CH B | SPK2 = 1+1- CH B / 2+2- Not Used

Chassis: 19" 2U height, 378mm total depth

Weight Net / Gross: 16kg / 17.5kg

Datasheet(s)